10/100-
TP TO FIBRE OPTIC SWITCHED HUB
FEATURES:-
TECHNICAL DESCRIPTION:
The 10/100-
100 Tx systems use a three level code, which is scrambled to reduce EMC. It transmits a code as an idle. 10 base T systems use a phase encoded system only transmitting on data, at other times a short pulse, the idle, is transmitted.
The fibre interface conforms to the 100 Fx specification. This is a non-
100 Base systems are only capable of transmission to 400m in a normal collision system.
Due to minimum packet time, length and transmission delay. This is fundamental to
CSMA systems. To operate above this limit a non-
Mechanically the unit is housed in a small metal enclosure to limit EMC.
SPECIFICATION:-
Copper interface
Conforms to 10 base T or 100 Tx as determined by auto negotiating fully compliant with IEEE802.3, IEEE 802.3u and IEEE 802.3 x standards.
Fibre Interface
Multimode |
Standard wavelength |
1300nm
|
|
Sensitivity |
- |
|
Output into 62.5um |
- |
|
|
|
Single mode |
Wavelength |
1300nm |
|
Sensitivity |
- |
|
Output into 9um |
- |
Temperature
Standard |
0 - |
Extended |
- |
|
- |
Power Requirements |
+ 5 to +12v at 4VA |
|
|
Weight |
187 grams |
CONTROLS
Switch |
One |
|
1 |
Unused |
|
2 |
Flow control |
Half Duplex (forced collisions flow control).
|
|
|
Full Duplex (IEEE 802.3x Paused based flow control). |
|
|
On = enable. |
3 |
Fx Duplex |
100 Base Fx duplex mode switch - |
4 |
FEFI |
Far end fault indication switch - |
Switch |
Two |
|
1 |
HD Flow Control |
|
2 |
FD Flow Control |
|
3 |
Indicators |
|
4 |
Unused |
|
DISPLAY
Copper |
Link / Activity |
On = Link / Blink = Activity |
|
Duplex / Collision |
Blink = Collision / On = Full Duplex |
|
Speed |
On = 100Mbps / Off = 10Mbps |
Fibre |
Link / Activity |
Blink = Activity / On = Link |
|
Duplex / Collision |
Blink = Collision / On = Full Duplex |
Power |
|
On - |
Dimensions
Height |
27.5 mm |
Width |
121 mm |
Length |
60 mm |
ORDERING INFORMATION
10/100- |
(C) |
Fibre connector |
SC or ST |
|
(F) |
Case Mechanical style |
F = Flange |
R = Rectangular |
(M) |
Mode |
Single mode = SM |
Multimode = MM |
(T) |
Temperature range |
Standard = S |
Extended = E |
(P) |
Power Connector |
Standard = S 1.3mm coaxial socket. |
3 pin Molex Right angle = 3/A |
|
|
|
3 pin Molex Vertical = 3/V |
If no (T) & (P) option is stated then standard will apply.
(Example :-
For price Click Here
* For single mode add £25.00